toshcon

Tuesday, 03 19th

Last updateMon, 15 Sep 2014 5am

 

MICROTRANSMITTERS
for industrial probes

 

• Suitable for 7685 Series and 565 Series

 

• IP 65 water-tight protection

 

• Water-tight output connector

 

• For immersion and in-line probes

 

• Easy installation and maintenance

 

pH and O.R.P. microtransmitter

 

The microtransmitter is a differential preamplifier enclosed in a water-tight housing and makes the characteristics of the measuring electrodes signal compatible to those of a normal connection cable.

 With this technically advanced solution it is possible to make connections at considerably long distances between the measuring probe and the control panel without the use of a shielded cable maintaining a high signal response speed and the complete absence of interferences, therefore greater precision.

 The connection between the microtransmitter and the panel regulator is made using a 4-pin waterproof connector type SZ 9490 and a normal 4-wire cable.

 The accessory type SZ 9491 consisting of SZ 9490 + 10 m marked cable is available.

 The microtransmitter is protected against eventual connection inversions.
It is mounted in the usual way on ST type probes, to be installed with PH 7685 - PH 7685.010 - PH 565.2 - MV 545.2 models.

 For unfixed mounting, the SZ 911 accessory must be used.

Recommended cable: 4 x 0.5 mm or 4 x 0.75 mm non shielded.

 Accessories

SZ 9490                       IP 67 connector for cable

SZ 9491                       10 mt cable and SZ 9490 connector

SZ 911                         Stopper

You are here: Home Products Process Control (Analytical) Micro Transmitter Redox – 080102.1